|MODEL NO:.|| ||LRS-75-5|
|RIPPLE AND NOISE||120mVP-P|
|VOLTAGE ADJUSTMENT RANGE||4.5V~5.5V|
|SETUP RISE TIME||1500ms.25ms(230V) 3000ms.25ms(115V) full load |
|HOLD-UP TIME||>20ms(230V) >12ms(115V)|
|INPUT||VOLTAGE RANGE||80~264VAC 120~370VDC|
|AC CURRENT (Typ.)||2.1A/115VAC 1.6A/230VAC|
|SURGE CURRENT||cold boot 48A/230V|
|LEAKAGE CURRENT||1.7mA 1800V|
|PROTECTION||OVER LOAD||Rated output power: 110 / 140%|
|Protected mode:Hiccup mode,recovers automatically after fault condition is removed|
|Protected mode:Turn-off output voltage,Rebootable recovery|
|SHORT-CIRCUIT||Can be short-circuited for a long time and recovers automatically after fault condition is removed|
|WORKING HUMIDITY||20~90%RH,no condensation|
|STORAGE TEMP. HUMIDITY||-40~80ºC 10~95%RH.no condensation|
|HEIGHT ABOVE SEA LEVEL||2000meters|
|Safety and Electromagnetic Compatibility||SAFETY STANDARDS||GB4943 /EN60950 TUV60950|
|WITHSTAND VOLTAGE||I/P-O/P:3KVac/10MA I/P-FG:1.5KVac/10MA O/P-FG:0.5KVAC/1MA |
|INSOLATION RESISTANCE||I/P-O/P, I/P-FG, O/P-FG, 100M Ohms/500VDC/25ºC/70% RH|
|GROUNDING TEST||Test condition :32A/2 minutes;ground impedance :<0.1ohmS|
|EMI STANDARD||EN55022 FCC CLASSB |
|EMC INTERFERENCE||EN61000-4-2,3,4,5,6,8,11 EN61000-6-2(EN50082-2)|
|PACKING||0.25kg;60pcs/G.W.:17kg/ Carton Size:37*22.2*33.2cm|
1.All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25ºC of ambient temperature.
2.Ripple & noise are measured at 20MHz ofbandwidth by using a 12 twisted pair-wire terminated with a 0.1uf &47uf parallel capacitor.
3.Tolerance: includes set up tolerance. line regulation and load regulation.
4.Line regulation is measured from low line to high line at rated load.
5.Load regulation is measured from 0% to 100% rated load.
6.Length of set up time is measured at cold first start. Turning ON/OFF the power supply very quickly may lead to increase of the set up time.
7.5V when the load factor 0-50%, the switching power less is reduced by burst operation, which will cause reipple and ripple noise to go beyond the specifications.
8.The ambient temperature derating of 5ºC /1000m is needed ffor operating altitude greater than 2000m (6500ft)
9.The power supply is considered a component which will be installed into a final equipmentt . All the EMC tests have been excecuted by mounting the unit on a 360mm*360mm metal plate with 1mm of thiickness . The final equipment must be re-confirmed that it still meets EMC driectives. For guidance of how to perform these EMC tests, please refer to "EMI testing of component power supplies" (as available on http:// www.meanwell.com)